About Sensor Module¶
The Sensor Module features up-to four universal inputs or outputs on a pluggable terminal block with 1-Wire bus master support.
The terminals can be used as both analog and digital input/output.
For example you can connect various external digital, analog or resistive sensors.
Also, you can communicate with other devices on a 1-Wire bus.
The two terminals - A on the left, B on the right - are connected to the HARDWARIO TOWER header signals P4/A4/DAC0 and P5/A5/DAC1.
|
Tip
The C pin is in default configuration connected also to the ground GND. It is possible to remove zero-ohm resistor R20 and solder it to the place R21. This way the C signal is directly connected to P7 and can be used as extra input.
Note
The VCC middle pin is possible to control by software. You can enable 3 V on this pin.
Features¶
Configurable terminal modes:
Analog input or output
Digital input or output
Pull-up resistor none/4.7 kΩ/56 Ω
Examples interfaces:
Digital temperature sensor on a 1-Wire bus (DS18B20)
Resistance temperature sensor (Pt 100, Pt 1000, etc.)
Analog temperature sensor (LM35, TMP37, etc.)
NTC temperature sensor
Control of digital 1-Wire relay block
Button or any type of switch
Voltage measurement
Plug-in 4-pin screw terminal block
Operating voltage range: 1.65 V to 5.5 V
Operating temperature range: -20 to 70 °C
Dimensions: 33 x 55 mm