Core Module R1 Debugging

Note

You can skip to the next chapter if you don’t have Core Module R1.

Core Module revision 1 does not have FTDI serial to USB converter. You need to connect your own converter to the UART2 to the pins TX2 and RXD2.

For example USB UART from SparkFun:

Or another example USB UART from Mouser:

Connect USB UART and Core Module into one PC’s USB host sockets and interconnect Core Module with USB UART by single wire USB UART RX (YELLOW wire on cable) and Core Module TXD2 (header pin 22) - have a look at Core Module Header drawing.

Warning

Beware of groud loop and ground voltage difference in case you do not use same PC to power Core Module and to connect USB UART.